Diskology Disk Jockey Guía de usuario descargar pdf (Pagina 22)

present,” simply set the drive to master.

5. When attaching the power cable connector and ﬂat

cable connector to the hard disk drive, make sure

that the orientation is correct. If you try to force it in

it could cause damage to the unit.

6. Always place the bare hard disk drive mechanisms

on the included electrostatic mats when connected

to the Disk Jockey.

7. A hard disk drive is a precision electromechanical

piece of equipment, make sure that you do not

directly touch the printed circuit board of the hard

disk drive or the connector pins directly with your

hands.

8. While the hard disk drive is in operation (ex. copy,

erase, etc.) do not touch the ﬂat cable or the power

cable.

9. Do not try to move the unit with the hard disk

drives attached to it, always remove the cable from

the hard disk drive(s) before moving the unit. Do

not move the unit by pulling on the ﬂat cable or the

power cable.

10. Hard disk drives may get very hot during operation.

Please take caution when touching the hard disk

drives after completing an operation as they may

remain hot for some time after.

NOTE – When using the modes in which the Disk Jockey

is connected to a computer (standard mode, spanning or

mirroring) you can only connect the Disk Jockey using one

interface, either USB or FireWire. Do not connect both a

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 53 54

Sin comentarios

Diskology Disk Jockey Guía de usuario Pagina 22